Vision 2310b, Инструкция по эксплуатации, Страница: 41 / 48

38
OPERATION
IMPORTANT NOTES
With the system armed, open the driver’s side door.
1. The siren will now
go off.
With the door still open, turn the Ignition ON and OFF 2.
the same number of times as the Disarm Code you pro-
grammed. (If no unique Disarm Code has been pro-
grammed, then turn the Ignition ON and OFF 6 times.)
When the siren finishes sounding for 30 seconds, the siren will turn
off and the system will then be disarmed.
Using Your Disarm Code
MANUAL DISARMING
Don’t worry that the siren doesn’t stop immediately after you enter your
•
Disarm Code. The system forces the siren to go off for the full 30 sec-
onds for security.
The siren will go off for a full 30 seconds when you open the door
•
unless
the system was armed in Silent Mode
. And since the 2310 comes with
a battery backup siren, you should use your siren key to disable the
siren temporarily to avoid disturbing the neighbors. When you open a
door, the system will trigger and the Status LED will flash rapidly. The
Status LED will then shut off when the system has been successfully
disarmed. DO NOT forget to re-enable the siren with your siren key
after the disarm sequence is complete.
If you enter an incorrect Disarm Code, or if you fail to enter your code
•
within 30 seconds, the siren will shut off for 8 seconds and then sound
for another 30 seconds (because the door is open). You must try to enter
your Disarm Code again during the next 30 seconds. If you fail again,
you must wait until the siren stops and starts again. DO NOT CLOSE
THE DOOR, or the siren will eventually stop and the system will not
recognize your Disarm Code.
You should close the door only when
you have successfully disarmed the system.
ON ST
ACC
OFF