Vision 2310b, Инструкция по эксплуатации, Страница: 40 / 48

VISION 2310B INSTRUCTION MANUAL
37 37
MANUAL DISARMING
Also known as “Emergency Reset” or “Force Reset,” Manual Dis-
arming allows you to disarm your 2310 system without the wire-
less remote. So long as you have your vehicle’s ignition key, you can manu-
ally disarm the 2310 with a special Disarm Code. This is useful if the
battery in your remote dies or the remote itself is lost or if RF interference
prevents your remote from disarming the system.
Purpose
The default Disarm Code is factory set to “6.” It is strongly recom-
mended that you change this code to something unique soon after your
security system is installed.
The following procedure will allow you to change the Disarm Code:
Disarm 1. the system.
(Or “Arm-then-Disarm” if repeating this procedure.)
Turn 2. IG on-and-off 20 times within 20 sec. of disarming. Hazard lights
will then flash 20 times.
Wait 3. until hazard lights flash 20 times, then turn IG on and leave it on.
The Status LED will light solid for 20 seconds and then it will start to 4.
flash very slowly (up to 30 times). Decide beforehand what code you
want to program (1~30). When the number of flashes matches the code
you wish to program, quickly turn off IG. The Status LED will now flash
the same number of times as the Disarm Code you just programmed,
and the siren will chirp 3 times and vehicle hazards will flash 3 times.
Programming Your Unique Disarm Code
NOTE:
Make time now to record your new Disarm Code and store it
in a safe place.