Vision 2310b, Инструкция по эксплуатации, Страница: 31 / 48

28
VISION 2310B INSTRUCTION MANUAL
28
GENERAL Operation
ERROR CHIRP
When you arm the 2310, the system ignores shock sensor “Warning” trig-
gers while Status LED is lit solid. If there is any other trigger while the
LED is lit solid (IG, Door, Trunk/Hatch, Shock Full Trigger), the siren
will chirp 2 times (“error chirp”) and the vehicle lights will flash twice and
that trigger sector will be bypassed. (No siren chirps will sound in Silent
Mode.) If the bypassed sector is later secured (i.e., the opened door was
later closed), the system will silently re-enable that sector 5 seconds later.
SENSOR BYPASS METHOD
This method of arming allows you to disable
the included shock sensor while keeping all
other alarm triggers active (e.g., door, igni-
tion, trunk/hatch).
Press Transmitter But-
tons 1 & 2 at the same time then release. The doors will
lock and vehicle lights will flash once (if so installed). The
siren will chirp 2 times quickly, and Status LED will light solid for 5 sec -
onds. Some triggers (sensor, door, etc.) may be bypassed if they occur while
the LED is lit solid.
(See “Error Chirp” below.)
Push Both
Buttons
AUTO-ARM
This method of arming is disabled by default —
see page 34 for pro-
gramming details . This feature automatically arms your system when
you do the following: (1) Turn Ignition ON, (2) Turn Ignition OFF, (3) Open
a Door and then (4) Close the Door. Twenty seconds later, you will hear 1
chirp and see 1 vehicle light flash. Five seconds later, the Status LED will
start flashing, and all zones will be secured (i.e., the system will be Armed).
NOTE : Doors will not be locked.
NOTE:
If you open a door before hearing the
Arm
chirp, the system will
wait until you close the door. After the door closes, the 20 second delay-to-Arm
timer will reset and start again.
PROGRAMMABLE