Vision 2310b, Инструкция по эксплуатации, Страница: 17 / 48

14
VISION 2310B INSTRUCTION MANUAL
This is a general purpose power output wire for +24v devices only. Never
c12v devices to this wire! This wire can be used to power the in -
cluded Siren (see page 9) and/or to power the Status LED (shown above).
But always keep in mind the 1-Amp rating of this wire! If you connect to
the Siren and/or LED, you should not connect this RED wire to anything
else. But if you connect the Siren to the +24v battery, then you have more
freedom to connect multiple, low-power 24v devices to this RED wire.
This is a general purpose ground that can be used to power any combina-
tion of devices up to 5-Amp. Keep in mind this is an Output, not an Input.
As such, you still must connect the two System Ground wires, as described
on page 16. DO NOT use this ground for your door locking connections!
1-Amp max!
1-Amp max!
5-Amp max!
Important Connection!
MAIN HARNESS
H1
This wire is a general purpose power output for automotive devices that
cannot run on 24v. It is commonly used to power optional devices that are
also grounded by the 2310’s GWA Output (see page 8). Take care not to
exceed the 1-Amp rating, especially when powering multiple devices.
The Status LED is used as a visual theft deterrent when the system is
armed. It also is used to notify the user if the siren goes off while away
from the vehicle, as well as for feature programming. Connections are
shown below in Fig-10 .
H1-RED
H1-BLK
(+) 24v Output
(–) Ground Output
H1-BLU/GRN
Status LED
H1-RED/WHT
(+) 12v Output
BLU/GRN BLU/GRN
FIG-10: Connecting the Status LED
24v BATTERY
RED
H1