Vision 2310b, Инструкция по эксплуатации, Страница: 42 / 48

39 39
TRANSMIT TER LEARNING
You can program additional remotes to your 2310 system, or
program a remote to replace one that you have lost. You can
program a total of 3 transmitters to the 2310.
Purpose
The following procedure will allow you to program transmitters:
Disarm 1. the system.
(Or “Arm-then-Disarm” if repeating this procedure.)
Turn 2. IG on-and-off 20 times within 20 sec. of disarming . Vehicle haz-
ard lights will now flash 20 times.
After the hazard lights flash 20 times, you have 10 seconds to press and 3.
release Button-1 on the first transmitter you wish to program. The si -
ren will then chirp once and the vehicle lights will flash once to confirm
your transmitter is learned. You will then have 10 seconds to press and
release Button-1 on the next transmitter you wish to program. (You can
program up to 3 total.)
Turn the Ignition on-and-off. The Status LED will flash the same num - 4.
ber of times as the Manual Disarm Code, and the siren will chirp 3 times
and the vehicle hazard lights will flash 3 times. Transmitter learning
is now complete!
Programming Transmitters
NOTE:
Initiating Transmitter Learning deletes all transmitters from
memory for security. You must therefore relearn all your existing re-
motes each time you want to learn new remotes.
OPERATION
NOTE:
You must have the Ignition Input wire connected to perform
the transmitter learning steps on this page! See pages 7 and 16 for wir-
ing details.