Viessmann Vitodens 333-F, Инструкция по эксплуатации

Страница: 98 / 136

Calling up coding addresses
1. Press
L
and
G
simultaneously
for approx. 2 s; confirm with
d
.
2. Select required coding address
"11" with
a
or
b
; the address
flashes; confirm with
d
; the value
flashes.
3. Adjust value "9" with
a
or
b
;
confirm with
d
. The green ON
indicator flashes.
Access to the coding addresses of
the parameters is open.
4. Select the required coding address
with
a
or
b
(see the following
table) and change the value.
5. To exit, set the value of coding
address 11
≠
9; then press
L
and
G
simultaneously for approx. 1 s.
Coding has been terminated.
Note
If setting the parameters is not con-
cluded via coding address 11, the
system automatically terminates
the parameter change after approx.
25 min.
Coding
Coding in the delivered condition Possible change
Burner
7d:0 Air factor correction 0 7d:
–
5
to
7d:10
Note
A change is only possible
if manual calibration was
first carried out via cod-
ing address "85".
Air factor correction ad-
justable from
–
5 to 10.
Each step represents an
air factor modification of
approx. 0.01.
82:0 Operation with natural
gas 82:1 Operation with LPG
83:0 Correction, ignition start
gas volume 0% 83:
–
10
to
83:+20
Correction, ignition gas
volume adjustable from
–
10 to +20%.
84:0 Start capacity correc-
tion 0 % 84:
–
8
to
84:7
Start capacity correction
adjustable from -16 to
+14 %.
One step equals 2 %.
Repairs
(cont.)
98
Troubleshooting
56
92
682
GB