Vicruns VD120 Series, Руководство пользователя

Страница: 18 / 174

Function Parameter Table VD120 Series Inverter User Manual
-
14
-
Chapter 5 Function Parameter Table
The symbols in the function table are described as follows:
○
——It indicates that the parameter setup value can be modified when the inverter is in run state;
◎
——It indicates that the parameter setup value cannot be modified when the inverter is in the run
state;
●
——It indicates that the numerical value of the parameter is the actually measured value, which
cannot be modified;
☆
——It indicates this parameter is “Factory default parameter” and can be set only by the
manufacturer.
F0 Basic Parameter Group
Function
Code
Parameter
Name
Setting Range
Factory
Default Value
Property
F0-00
Motor Control
Mode
0: V/F control
1: SVC
0
◎
F0-01
Running
Command
Source
Selection
0: Control panel command source
(L/R OFF)
1: Terminal command source
(L/R ON)
2:Communication command
source (L/R flashes)
0
○
F0-02
Main Frequency
Source A
Selection
0: Digital setting (F0-09,
UP/DOWN can be modified, no
memory when power failure)
1: Digital setting (F0-09,
UP/DOWN can be modified,
memory when power failure)
2: AI1
3: Reserved
4: Reserved
5: PULSE setting
6: MS reference
7: Simple PLC
8: PID
9: Communication setting
10: Keypad potentiometer
10
◎
F0-03
Main Frequency
A Gain
0.000~10.000 1.000
○
F0-04
Auxiliary
Frequency
Source B
Selection
Same as F0-02 (Main Frequency
Source A Selection)
0
◎