43
8
Instructions for the product disposal after its useful life period
VIADRUS a.s. is the contract partner of the company EKO-KOM a.s. with the client number F00120649. The
packaging complies with EN 13427.
The packaging should be disposed of as follows:
-
plastic foil, cardboard package - use the special waste collection point
-
metal tightening tape - use the special waste collection point
-
wooden base is intended for single use and cannot be further used as a product. Its disposal is subject to the
law 477/2001 Sb. and 185/2001 Coll. as amended.
Individual parts of the boiler should be disposed of as follows:
-
exchanger, piping, shell - use the special waste collection point
-
other metal parts - use the special waste collection point
-
insulation material - through a firm dealing with waste collection and disposal
In case of loosing the use properties of the product, back collection service can be used (if applicable), in
case the manufacturer states it is waste, the waste should be disposed according to the valid legislation of
the country.
9
Important warning
•
The boiler may only be used for the intended purposes.
•
The boiler can be operated only by adults familiar with this instruction manual. Do not leave unattended
children near the operated boiler.
•
The boiler is not intended for use by persons (including children) whose physical, sensory or mental
disability or lack of experience and knowledge prevents them from using the appliance safely, if they
are not supervised or were not instructed to use the appliance by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
•
A necessary condition to operate the boiler is the chimney lining due to possible formation of
condensation in flue gases due to their low temperature, especially at the min. boiler output. Lining
material must be resistant to chemical effects of condensate.
•
If there is a danger of development and penetration of combustible vapours or gases into the boiler
room or at works with temporarily developed fire or explosion danger (gluing the floorings, painting
with flammable paints etc.), the boiler must be put out of operation before such works.
•
When transporting fuel into the combustion chamber before firing up, the volume of fuel in the retort
must be checked visually and not by putting hands into fireplace. There is a danger of injury caused by
rotating screw shaft.
•
It is FORBIDDEN to use flammable liquids for the boiler firing.
•
During the boiler operation, it is FORBIDDEN to overheat it in any way.
•
Do not put any objects made of flammable materials on the boiler and within a distance smaller than
the safe distance from the boiler.
•
When removing the ash from the boiler, no flammable substances must be at the minimum distance of
1500 mm from the boiler. The ash must be put into incombustible containers with lids. Use protective
equipment.
•
After the heating season, it is necessary to clean the boiler including the flue pipe. The boiler room
must be kept clean and dry.
•
It is forbidden to interfere with construction and electrical installation of the boiler.
•
In case of reaction of the two-way safety valve, when there could be refilled water that does not
conform to CSN 07 7401, it is necessary to adjust water in the system so that it again conforms to this
standard.
•
In the system, it is necessary to install a safety valve with max. overpressure of 250 kPa (2.5 bar), which
dimensions must correspond to the boiler nominal output. For further questions please contact our
contractual installation companies and service organizations.
•
In case of the failure, the boiler switching off or in case of the fuel absence, protection against frost is
not provided. The boiler regulation does not solve the heating circuit protection against freezing. If the
heating system is not used daily during the winter period, it is necessary to drain the water.
•
Low fuel quality can significantly affect the boiler output and emission parameters.
•
When mounting, installation and operation of the appliance it is necessary to meet the standards valid
in the relevant destination country.
In case of failure to comply with these conditions, warranty repairs cannot be claimed.
