21
5.2.4
Switchboard mounting to the fuel tank
Fig.
№
. 14
Switchboard mounting to the fuel tank
1.
Screw the switchboard to the fuel tank side.
2.
Perform wiring according to the diagrams in Chap. 5.2.8.
5.2.5
Mounting of the cleaning tools
To mount or dismount the brush and tip for the spike (if included), use common assembly tools and leather gloves.
5.2.6
Mounting of emergency fire-extinguishing equipment
In the cleaning hole cover there is a pipe for water inlet with 1/2“ connection that serves for BVTS valve or TS 130
or STS 20 interconnection. The interconnection can be carried out by means of flexible (stainless) hose. It must be
removable connection of the valve and the pipe in the cleaning hole cover due to the possibility of disassembly. The
valve sensor is to be positioned in the sensor holder located on the fuel feeder.
Note: The valve sensor must be positioned in the sensor holder without the valve basin that is included in the
delivery.
Emergency fire-extinguishing equipment function:
In case of fuel fire penetration into the feeder (temperature in the feeder has reached 95
°
C), BVTS or TS 130 or
STS 20 valve opens the cold water inlet into the hopper and the burning fuel is extinguished, after the temperature
on the sensor has dropped o 6
°
C, the water supply is stopped. Then it is necessary to dismount the motor with the
screw shaft and stainless insert and carry out cleaning. This is followed by the re-assembly. Check whether the
valve does not let flowing the cold water into the tank; if yes exchange the valve.
1.
Switchboard
2.
Screw M6 x 16 (4 pc)
3.
Mudguard washer 6.4 (4 pc)
4.
Flexible washer 6.4 (4 pc)
5.
Nut M6 (4 pc)
