Vertical Express ICON 32, Руководство по эксплуатации продукта

Страница: 59 / 220

ADJUSTMENT
Vertical Express Product Manual 2-19 88500 v.1.0
Adjustment Section Selector Tape Magnet Installation
Magnet Placement
(continued)
In the next step, a metal scribe will damage the tape.
2. Use a marker that will not damage the tape, and mark the tape at the top of the
selector box. See Figure 5 on page 2-21.
3. Move the car out of the way to provide access for installation of the magnets.
4. Determine how many initial terminal slowdown magnets are to be installed.
5. Start placement of the top edge of the first terminal slowdown magnet "D"
inches above the top of the selector box mark. Place the magnets end to end
with the south polarity facing out (yellow side out).
6. Start placement of the directional limit magnets 9
1
/
4
" below the top of the selec-
tor box mark. Place two 8" magnets end to end with the south polarity facing out
(yellow side out).
The magnets must be extended up the hoistway far enough so that the
selector sensors cannot run off of the magnets at the extreme limit of travel
up past the top floor. See Figure 8 on page 2-24.
Floor Landing and Close Floor Leveling Magnet Installation
1. Position the car so that it is level and at the top landing.
In the next step, a metal scribe will damage the tape.
2. Use a marker that will not damage the tape, and mark the tape at the top of the
selector box. See the following figures for this procedure:
Floor Landing - See Figure 6 on page 2-22.
Close Floor - See Figure 7 on page 2-23.
3. Move the car out of the way to provide access for installation of the magnets.
4. Position the template (814CH001) on the tape as follows:
a. The template top at the top of the selector box mark on the tape.
b. The sides of the template with the sides of the tape.
5. Place and center an 8" magnet in the right-hand slot of the template, and ensure
that the yellow stripe of the magnet (south pole) is facing out.
A close floor is defined as a floor with 4"- 16" of travel to the floor above it. The
template can be lifted over the nearby magnet to allow the installation of the "close
landing" magnet.
6. After installation, verify the position of the magnet.
a. The magnet top is 3
3
/
4
" below the top of the selector box mark.
b. The magnet side is
1
/
2
" from the edge of the tape side.
7. Repeat the above steps for each floor—except when performing step 5 (above),
a close floor's 8" magnet would be placed on the left-hand slot of the template
with the yellow stripe of the magnet (south pole) facing out. The top landing
always uses the right-hand slot of the template.