TECHNISCHE ANGABEN
27/94
CN929-7015M002
Dieselbe Anagabe kann auf folgendem Flussdiagramm
erscheinen:
Zum Ein-/auszuschalten des Arbeitsmodus PROTECT
müssen die Tasten CHANGE CONFIG und START/PROT
gemeinsam gedrückt werden; wenn dieser Modus
eingeschaltet ist, leuchtet die jeweilige LED-Anzeige auf
der vorderen Schalttafel auf.
MERKE
Die Tasten START SCHUTZ 1 und 2 sind aktiv, auch
bei HV-Einstellung auf EIN.
In dem Modus START fährt der Controller fort, die
Hochspannung vorzusehen, trotz des zugeführten Stroms.
Die Hochspannung ist nicht freigegeben, wenn der
zugeführte Strom beim Betrieb im Modus SCHUTZ über
den Schutzstand hinausragt.
EINHEIT KONFIGURIEREN
Mit Hilfe der Menütaste kommt man zum
Konfigurationsmenü.
MERKE
Wenn die Hochspannung freigegeben ist, können die
Controller-Einstellungen nicht geändert werden; sie
können nur bei HV-Einstellung auf Aus geändert
werden.
Meldungen, die zu den Modustasten gehören
Bei Betätigen der MODUS-Taste kommt die Einheit
zum Stromkreiskonfigurationsprogramm, das beendet
werden muss, um zum Hauptmenü zurückzukehren.
Die Einheit geht automatisch aus diesem Menü
heraus, wenn innerhalb der voreingestellten Zeit von 15
Sekunden keine Taste betätigt wurde.
Druckeinheit anwählen (Pressure Unit selection)
Bei erstmaligem Betätigen der Hauptmenütaste kann
die Druckmesseinheit angewählt werden; in der Tat
zeigt das Display zeigt die letzte Einstellung der
Einheit. Bei Betätigen der Taste BEARBEITEN kann
die Messeinheit geändert werden; folgende Einheiten
können angewählt werden:
mbar, Torr und Pascal
P R E S S U R E
U N I T
T O r r
*
Die erfolgte Anwahl durch Betätigen der ENTER-Taste
bestätigen.