Vaisala Veriteq viewLinc 3.6, Руководство администратора

Страница: 67 / 122

Swapping Loggers
viewLinc 3.6 Administrator Guide 57
To swap a logger:
1
Ensure the new logger has the same settings as the
logger to be swapped (see System | Loggers, or refer to
the vLog, Spectrum or your Vaisala product User Guide) :
Note:
Each Vaisala Veriteq logger must be reviewed
separately using vLog or Spectrum, and the
COM port to which they are connected must be
selected from Tools | Options.
•
COM port/IP address.
Logger is on the same COM port
(attached to the same cable). If you are swapping a 300
Series Transmitter connected as a network device,
ensure the new transmitter has the same IP address.
•
Name.
Logger is not retired or deactivated.
•
Status.
Logger is not in active alarm mode.
•
Sample Interval.
Loggers have the same sample
interval.
•
Channels.
Loggers have the same channels enabled
and be using the same units of measure for each
matching channel.
•
Audit Trail.
Vaisala Veriteq loggers are not linked to a
vLog Audit Trail.
2
From System | Loggers, select the Host and then the
logger you want to swap (remove).
3
On the Logger menu, select
Pause Alarming
.
4
In the Pause Alarming screen, you can add a comment
about why you are swapping loggers, and specify the
expected duration for the pause. This will ensure no
communication or threshold alarms are triggered when
disconnecting the logger.
5
Click
OK
.
6
Disconnect the logger you want to swap, and connect the
new logger. If you are swapping a 300 Series
Transmitter, unplug the power source and plug it in
again.
7
Click Refresh to update the logger list (you may have to
wait a few minutes for the logger to appear). If the new
logger has been previously swapped it will be found in
the list of deactivated loggers (to view, click Show
Deactivated Items on the System | Loggers page).