Installation instructions for geoTHERM exclusive VWS 0020051614_00
44
6.10
Fitting the cladding and the operating panel
Fig. 6.20 Installing the lateral cladding
• Pass both lateral claddings (Fig. 6.20, item
1
and
2
)
below through the frame of the heat pump, push each
cladding backward and screw them in the front with
four fixing screws respectively.
1
2
Fig. 6.21 Installing the upper cladding section
• Place the anterior upper cladding (Fig. 6.21, item
1
) on
the heat pump and fasten it with two bolts.
• Press the clip fastener of the rear upper cladding
(Fig. 6.21, item
2
) into the corresponding apertures of
the lateral cladding until they engage.
Fig. 6.22 Installing the anterior cladding
• Pass the line of the connecting plug for the console
terminal (Fig. 6.22, item
3
) and by using the vrnetDIA-
LOG accessories, the vrnetDIALOG connecting plug
(
4
) (230 V-power supply) through the aperture of the
anterior upper cladding (
2
).
e
Danger!
Risk of electric shock!
If the vrnetDIALOG accessory is not
being used or does not receive its power
supply from the heat pump, the
vrnetDIALOG connecting plug (4)
(230 V supply) must remain secured in-
side the heat pump.
• Hook the anterior upper cladding into the upper clad-
ding (Fig. 6.22, item
1
) then, press it into the clip fas-
tener on the frame. Fasten the cladding with two
bolts, as shown in Fig. 6.21.
6 Electrical installation
Содержание geoTHERM exclusive
Страница 91: ......
Страница 92: ...0020051614_00 GB 102008...
