Vahle VCL Series, Перевод оригинальной инструкции по эксплуатации

Страница: 79 / 96

COMMISSIONING 77
Step 3
Required tools:
⚒
Hexagon socket
Assembly instructions:
1. Tighten the screws with a torque of 5.5 Nm (50A
feed) or 9.5 Nm (100A feed).
Step 4
Required tools:
⚒
Sheet punch set / pot drill / hole saw
Assembly instructions:
1. Find the exact position of the feed terminal on the
supplied system plan, and make a hole (Ø 30
mm) in the VMT at this point so that the cabling
of the feed terminal can be guided out. Note the
additional specifications in chapter: „5.3.12 “.
Step 4
Required tools:
⚒
Cylinder Saw (Siehe 5.4.1 Installation aids VMT)
Assembly instructions:
1. Find the exact position of the feed terminal on the
supplied system plan. The feed terminal must
have a distance of 200 mm from the hanger on
the side to which the connecting cables are led
away.
2. Make two holes (Ø 30 mm) in the VMT in this area
between feed terminal and hanger so that the
connecting cables of the feed can be led out.
Note the additional specifications in chapter:
„5.3.12“.
3. Deburr the sections.
4. Insert the edge protector (4.6.7 Edge protector
for line feed) in the holes.
NOTICE!
Feed terminal at the end segment in the VMT
► When mounting in the VMT, a hole (Ø 30 mm) with edge protection must also be made in the VMT at the
feed terminal on the end segment in order to safely feed through the connecting cables.
► See 5.3.3 End segment with feed terminal (fixpoint).