Vahle VCL Series, Перевод оригинальной инструкции по эксплуатации

Страница: 49 / 96

COMMISSIONING 47
CAUTION!
Danger of crushing between the individual components!
During assembly there is a risk of crushing of the extremities between the individual
components.
► Take care of your extremities.
► Wear personal protective equipment. (see Chapter: 2 )
NOTICE!
The conductor rail material is susceptible to corrosion.
Corrosion can occur when working on the conductor rail with tools.
► Only tools that have not previously been used for ferritic materials may be used.
► Own tools should be used for the different materials (aluminum, copper, stainless
steel).
► Chip-forming work (grinding etc.) must not be performed in the vicinity of the con-
ductor rail system.
NOTICE!
The following points have to be strictly observed during assembly!
► Appropriate handling of materials.
► Clean and metallic bright surfaces on all contact points.
► Smooth crossovers, free of burrs, of the conductor rail profiles at the ends in order
to avoid breakdowns and a high carbon brush wear.
► Firm tightening of all screws using the screw lock provided and observing the stat-
ed tightening torques.
► Exact alignment of the conductor rail to the guide system.
► Damaged materials must not be installed.
► Observe all applicable regulations governing installation of the plant.
5.2 Operation/decommissioning
5.2.1 Operation
Operation is understood to be trouble-free, normal operation. Check intervals as per the maintenance sched-
ule in Chapter: „7 “. If defects occur, stop using the system to prevent damage.
5.2.2 Decommissioning
Switch off the system and secure it against restarting. Disconnect the entire power supply from the system
physically.