Vahle VCL Series, Перевод оригинальной инструкции по эксплуатации

Страница: 74 / 96

COMMISSIONING 72
Step 1
Prerequisites:
 Upright must be installed correctly and straight.
Required tools:
⚒
Wrench/ reversible ratchet
Assembly instructions:
NOTICE!
The installation of the clamping console AH-VMT-SPW
is shown as an example. Except for the AV-VMT-BS
console, all consoles are installed similarly as shown.
► The AV-VMT-BS clamping console is fixated with
drill screws (ST 5.5 = 7Nm).
1. Attach the clamping consoles or the screw con-
soles (dependent on the selected type). Tighten
the M10 screws to a torque of 15 Nm. Ensure
that the clamping springs always face upwards.
For other clamping springs, please use the
torques specified in the table above.
Step 2
Assembly instructions:
1. Lay out the VMT sections at the approximate po-
sition according to the installation plan, and then
hang them in the mounted hangers.
NOTICE!
The connectors must be turned before assembly so
that the clamping springs face downwards.
Step 3
Assembly instructions:
1. Insert the profiles as shown into the hangers and
lock the clamping springs using the installation
pliers (next illustration). Make sure that the
springs have properly snapped in place.