V-TEK TM-402, Руководство пользователя

Страница: 93 / 298

D292105.7b.fm Configure HMI Settings
Chapter 4: Setup 4- 21
keys move the Pick Head forward and backward. The Left/Right Arrow keys
move the tape left and right in the Taper Track .
b. When the Nozzle is centered over the tape pocket, press Set Place Position
to set the position.
c. Press the right Arrow Key to move to the next Job Wizard screen.
11. Set Place Nozzle Height The Pick Head ’s Z Axis (up/down) position needs to be
set at the Place position.
a. To manually set the Place Actuator to
the correct nozzle height, press Place
Extend
b. Use a 2.5mm hex wrench to hold the
Actuator Adjustment Screw in place
from the bottom, while loosening the
Jam Nut on top of the Actuator
Adjustment Screw with an 8mm open
ended wrench . Lower the Nozzle until
the part is barely touching the top of
the pocket in the
Place Location .
c. Tighten the Jam Nut .
d. Press Place Retract to retract the
Nozzle to a safe height.
e. Press the right Arrow Key to move to
the next Job Wizard screen.
Step 6:
Setup HMI
PICK
HEAD