V-TEK TM-402, Руководство пользователя

Страница: 154 / 298

6-10 TM-403 User’s Guide
Preparing to Run a Pre-programmed Job D292105.8b.fm
3. Press Move To Pick , then press Pick Part. Observe the
vacuum sensor which is located on top of the head to
see if it is set correctly for the current part. The numbers
should be lit in
green with components on the nozzle
and red if components are not.
Note: See the Chapter 6: Troubleshooting for vacuum
sensor adjustment procedures.
4. Return to the Head Setup Tab .Press Move To Place , then press Place Part.
Check that the Blow Off Pressure is set correctly for the
current part. The Blow-off Pressure Gauge is located on
the front of the Pick Head Bridge . If components are not
dropping properly, pull the gauge out and rotate to adjust
pressure levels. When the desired pressure level is
reached, push the gauge back in.
Setup Vision
The TM-402 Vision System will automatically revert to the previous inspection. If the
same part is being run, there is no need to retrain the camera. Proceed to Step 8. If a dif-
ferent job/inspection is being run, follow the setup instructions in
Chapter 4: Setup .
Step 7:
Setup
Vision