V-TEK TM-402, Руководство пользователя

Страница: 51 / 298

D292105.6a.fm Job Tab
Chapter 3: Human Machine Interface 3-9
A. Tape Pitch is determined by the carrier tape
selected. Use the Pitch Setting Guide on the taper to
determine the correct pitch. Press the Tape Pitch
field to open a keypad and type in the desired value.
B. The Continuous Advance button advances the
tape through the Taper . It will continue to advance
until Continuous Advance is pressed a second time.
C. Seal Type toggles between PSA and Heat seal, select correct seal type.
D. The Set Point fields are only active when Heat Seal is selected. These fields are
used to set the desired temperature for the Inner and Outer Sealer . Enter the cor-
rect value in both fields, then press the right Arrow Key to move to the next Job
Wizard screen.
Note: The TM-402 accommodates a wide range of carrier tapes and cover tapes. Set-
tings may vary from one tape product to another. The recommended starting point is 90°
C. The maximum recommended operating temperature is 160° C
. The temperature for
each seal shoe should be increased or decreased as needed after running a peel force
test.
4. The fourth Job Wizard screen enables or disables the tape Leader .
A. Leader State toggles between Enabled and Disabled.
B. When the Leader State is set to Enabled, pressing the Leader Length field will
open a keypad. Type in the desired value, then press the right Arrow Key to
move to the next Job Wizard screen.
A
B
Job Wizard Step 4