V-TEK TM-402, Руководство пользователя

Страница: 148 / 298

6-4 TM-403 User’s Guide
Preparing to Run a Pre-programmed Job D292105.8b.fm
Preparing to Run a Pre-programmed Job
The initial set-up and configuration of a new job are covered in Chapter 4: Setup . This
chapter discusses the procedure for setting up existing jobs, running a job and routine
operator tasks.
Caution: Users should always wear protective eye wear when operating
or maintaining the TM-402.
Power up the System
1. Power up the machine by turning the Main Power Switch , which is
located on the right side of the machine, to the ON position.
2. Press the blue Reset button on the left side of the machine.
Home Motors
Note: The TM-402 only needs to be homed once after each power up or emer-
gency stop. Once the motors have been homed, they remain homed until the
machine is powered down.
1. The HMI will open to the Job Tab with a red Home Required button at the top of
the Tab Menu and the other tab buttons grayed out. Press Home Required to
open the Homing Status window.
Step 1:
Power
Up
Step 2:
Home
Motors