98
D292469I
To adjust the Die (Pickup Tip) on the Y Axis (front to back) direction, there are
mechanical adjustments made with positioning screws:
1.
Place the system in
Single Step Mode
by pressing the
SINGLE STEP
key.
2.
Cycle the system until the pickup is holding a die at the Down position over the
Rotating Spindle of the Facet Inspection Camera.
3.
Make adjustments using the Positioning Screws. The images below demonstrate
the Positioning Screws that may need to be adjusted.
Z-Axis Adjustment Screw
Optical Carriage
Y-Axis Adjustment Screw
Fasten top and bottom.
Y-Axis Adjustment Screw
Содержание Royce DE35-ST
