V-TEK Royce DE35-ST, Руководство пользователя

Страница: 113 / 146

112 D292469I
Adjusting Pickup Height at the Pick Position
1. Turn the DE35 OFF .
2. Lower the Eject Head to its lowest height.
3. Turn the DE35 ON and allow it to reset.
4. Install sample into the work holder.
5. Position a die sample over the Eject Head.
6. Press
SINGLE STEP
.
7. Press the Foot Switch until the pickup arm lowers to the pick position and the
LCD displays
TURN ON PICKUP VACUUM
.
8. Press the
COARSE/FINE
key so that the LCD also says
FINE
.
9. Press the
DOWN
key until the display reads
REACHED LIMIT
.
10. Raise the Eject Head up until the display reads
PICKUP IN CONTACT
.
11. Press the
UP
key until the display reads
PICKUP CLEAR
by one fine step.
12. Press
SINGLE STEP
to return to normal operation. The machine will now lower to
this height during normal operation.
Adjust Pickup Height at Place Positions
1. Turn
ON
the DE35 ST and let it reset.
2. Install a sample into the work holder.
3. Position a die sample over the Eject Head.
4. Press
SINGLE STEP
.
5. Press the Foot Switch until a die is picked, the tip is over the Waffle Pack and the
LCD displays TURN OFF PICKUP VACUUM .
6. Press the COARSE/FINE key so the LCD displays FINE .
7. Press the DOWN key until the LCD displays PICKUP IN CONTACT by one fine step.
NOTE:
If the LCD displays
PICKUP IN CONTACT
when moving to this position,
press the UP key until the LCD displays PICKUP CLEAR , then perform step seven.
8. Press SINGLE STEP to return to normal operation.
9. The machine will now lower to this height during normal operation