V-TEK Royce DE35-ST, Руководство пользователя

Страница: 19 / 146

18 D292469I
2. Plug the Interlock Cable into the connector located on the panel to the right
of the DES.
3. Install a Wafer with die on the Wafer Holder.
4. Align the die on the X and Y Axis by rotating the wafer in the holder. Final
alignment can be done with the Theta Adjustment of the Wafer Holder.
5. Ensure the Wafer Holder is closed, and the Micro Switch is made. (Adjust the
lever on the frame until the switch is made.)
Check Follow Focus & Zoom Center
NOTE:
The Camera and Zoom Lens have been set up to ensure that the lens is
“zoom centered” and "follows focus" throughout the zoom range. Any
adjustment of the camera tube height or alignment is strongly discouraged
without first consulting the manufacturer.
1. Turn on the Monitor and the PC. The Royce TV program will automatically
launch.
2. Click on the ' + ' button and then move the cursor over to the live video image.
Click in the top left corner and drag down to the bottom right corner and
release. This should create a cross in the middle of the video image.
3. Zoom Camera Lens into maximum zoom.
4. Using the hand wheels on the DES, align a die with the crosshairs in the
upper right segment of the Monitor. Align the die so the left and bottom
edges of the die are on the crosshairs. Adjust the focus for a clear
presentation.
5. Zoom the Camera Lens out to minimum zoom. The presentation should stay
in focus and the die should not move away from the crosshairs.
NOTE: If the alignment or focus changes when doing the above, see Optical
Center and Follow Focus in the Maintenance section of this manual.