V-TEK Royce DE35-ST, Руководство пользователя

Страница: 21 / 146

20 D292469I
7. Loosen the large Thumbscrew on the top of the Camera Mount. Unscrew both
adjustment screws until the crosshairs are past the mark then lightly snug the
large Thumbscrew. Turn the adjustment screws until the crosshairs bisect the
mark on the tape left by the tip. Tighten the large Thumbscrew. The crosshairs
should now be at the center of the tip.
8. Press the Eject Test key twice. The needle should now come up and penetrate
the tape and retract, leaving a mark. Align this mark with the center of the
crosshairs.
If the needle does not leave a mark, raise the needle height by turning the Stop
Ring on the Eject Actuator counter clockwise. This is the large ring just below the
Eject Head.
If using motorized ejector (DES-AUM), the needle height can only be adjusted
during the eject step of a single step cycle. Press the foot pedal to start a cycle
and step through until the LCD reads Lift Eject Needles XXXX . Press the +/-
keys until the desired eject height is shown, then step on the foot pedal again to
raise the needles. Press NO to cancel the cycle and lower the needles.
NOTE: This ring has a nylon tipped Setscrew that should be snugged up to ensure
it does not vibrate out of adjustment.
9. Make adjustments to the Eject Head position by loosening the large thumbnut
on the Eject Actuator Arm of the DES. Using the (2) small thumbnuts, move the
Eject Needle to the crosshairs. With a square or rectangular Eject Head, center
the tip between the needles.
NOTE: Make sure the needle is down when moving the eject head.
10. When the Eject Needle is aligned with the crosshairs, move the Pickup Tip over a
clear spot on the tape and mark the tape again. Press NO after marking the tape
to move the tip out of the way.
11. Press the Eject Test key again and check the needle position with the tip. Make
any adjustments necessary to align the two.
12. After aligning the tip with the needle move the Wafer and place a die under the
crosshairs. Carefully dissect the die with the crosshairs and zoom in to present
as large a presentation as possible. Recheck the alignment to ensure the
crosshairs are centered on the die.
13. Click on the '
#
' in the Royce Technical Video software. Move the cursor over to
the live video image. Click on the top left corner of the die and drag down to the
bottom right corner of the die and release. This creates a cross hair along each
edge of the die. The die is now correctly targeted.