V-TEK Royce DE35-ST, Руководство пользователя

Страница: 64 / 146

DE35-ST Operating Instructions
D292469I 63
NOTE: The pickup tip will only sense forces pushing up on the bottom of the tip.
If the pickup tip cannot be adjusted any further in the down direction, the
message
REACHED LIMIT
will appear briefly in the display, accompanied by 3
beeps.
+ /- Keys
If the adjustment being made is a time adjustment, such as delay
time, then the + key will increase the time and the – key will
decrease the time. Each can use either a COARSE or FINE
increment.
NOTE: Adjustments made are permanently stored and will remain
after the machine is turned off. At any time a limit is reached,
REACHED LIMIT will show on the display.
Pick & Place Cycle
The following is a breakdown of the full pick and place cycle, with a description of the
action and adjustments allowed when in Single Step.
1. TURN ON TAPE VACUUM
Vacuum is applied through the Eject Head to hold the tape in place. No
adjustments are necessary or allowed.
2. ARM GO TO PICK POSITION
The Pickup Arm will move to position the tip directly above the center of
the next die to be picked. In this position the Left/Right Arrow keys will
move the Pickup Arm left or right to align the tip with the Eject Needle if
necessary.
3. GO DOWN TO PICK HEIGHT
The Pickup Head will lower to the height at which it will pick the die. This
position should be set so that the Pickup Tip either just contacts the die
or is just out of contact with the die. This height can be adjusted using
the Up/Down keys along with the Coarse/Fine keys in this position.
4. TURN ON PICK UP VACUUM
Vacuum is applied through the Pickup Tip. No adjustments are
necessary.