Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
of Utilimaster.
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
91
For Assistance Call: 800-237-7806
Parts On-line:
https://parts.utilimaster.com
Reach—Body Service Manual
Fax: 574-862-7637
Installation
1. Use a grinder to clean off any old structural
adhesive.
2.
Clean contact surfaces at floor and on panel
with isopropyl alcohol and allow to dry.
3. Assemble structural adhesive gun by removing
the cap from the structural adhesive cartridge
and attaching the mixing tube to the cartridge,
pressing firmly.
4. Place the plunger into the back of the
cartridge.
5. Dispense structural adhesive on a scrap piece
of cardboard until the mixture comes out
green. The bead will be approximately
the length of the mixer tip which means
the structural adhesive is adequately
mixed.
6. Apply structural adhesive approximately
1” in from the perimeter of the access
panel.
7.
Center access panel over opening in floor
and press firmly.
8. Apply weight to the panel and allow
structural adhesive to bond to floor.
9.
Secure floor mat to floor with spray
structural adhesive and roll with a floor
weight to bond.
Purge Mixer Tip
CAUTION: The structural adhesive will cure in approximately six minutes once it is exposed to air.
Do NOT interrupt or delay the process once the structural adhesive application has begun.
Adhesive cartridge and plunger assembly
Sleeve Adapter
Cartridge
Plunger
Mixer Tip
Sleeve
Cartridge
Plunger
Caulking Gun