Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
For Assistance Call: 800-237-7806
Visit us at:
www.utilimaster.com
70
Reach—Body Service Manual
E-mail:
Rollers
Removal
1. Open door.
2. Remove rivets from end hinge.
3. Remove roller from track and set aside.
Installation
1. Insert roller into hinge.
2. Place roller into track.
3. Install end hinge with 1/4 x 1-1/8" elevator bolt and nut.
4. Lubricate with a light oil (Utilimaster P/N 04202540).
Seals
Header Seal Removal
1. Remove rear header cladding.
2. Remove rivets in
extrusion and remove
extrusion.
3.
Use a flat-blade screwdriver to pry apart the
crimped extrusion.
4. Remove seal from track and discard.
Header Seal Installation
1. Slide seal into upper track.
2. Crimp the extrusion.
3. Install extrusion with rivets.
4. Install rear header cladding.
Door roller
Header seal