3.3.3 Controller
Cable
The second cable to be attached is the 20” 12-pin to 12-pin data cable that connects the Controller to the
Module C and Mass Flow Controller. Begin by inserting the
single end
of the data cable (without the mass
flow controller connector) to the Controller as shown. Then, plug the other 12-pin connector into the
Module C. The breakout cable on that end is connected to the Mass Flow Controller, which is the central
port on the side of the pump enclosure, as shown.
3.3.4 Air
Line
The Air line is a 30” black cable with Colder fittings at each end. It connects to the Module C and then to
the pump enclosure as shown, on the far right.
18
