Uponor AquaSAFE, Руководство по установке, Страница: 10 / 72

Handling and storing Uponor AquaPEX piping
and components
Although not comprehensive, the following highlights the
most common guidelines and listing requirements when
handling Uponor AquaPEX piping and Uponor AquaSAFE
system components:
• Install Uponor systems according to the installation instructions
of the manufacturer. Failure to follow the instructions and
installation guidelines can result in system function failure.
• Do not store sprinkler assemblies or cover plates in areas that
may exceed 100°F (37.8°C).
• Uponor PEX piping is listed for fire protection systems that do
not exceed 130 psi (8.9 bar) 120°F (48.9°C).
• Do not use PEX piping where temperatures and pressures
exceed ratings.
• Store Uponor PEX piping in its packaging under cover to avoid
dirt accumulation and exposure to direct sunlight. Do not
expose PEX piping to direct sunlight for more than 30 days.
Do not use piping that has been exposed to direct sunlight for
more than 30 days.
• Do not install PEX piping in direct view of fluorescent lighting.
Do not use piping that has been exposed to direct fluorescent
lighting for more than 30 days.
• Do not weld, glue or use adhesives or adhesive tape on
PEX piping.
Note: You may temporarily affix adhesive tape to Uponor PEX
piping during installation. However, to protect the integrity of
the system, the tape should not be permanent. Remove the
tape and residual adhesive after completing the installation.
• Do not apply open flame to PEX piping.
• Do not install PEX piping within 6" of any gas appliance vents,
with the exception of double-wall B-vents or plastic vents,
which have a minimum clearance of 1".
• Do not install PEX piping within the first 18" of a connection to
a water heater, unless otherwise allowed by code. Follow your
local code requirements.
• Do not install PEX within 12" of any recessed light fixtures, unless
the PEX piping is protected with suitable insulation.
4 l Uponor AquaSAFE System Installation Guide