Universal Laser Systems ULS-25PS, Руководство по эксплуатации

Страница: 60 / 100

Since the driver automatically mirrors the entire page when the “RUBBER STAMP”
option is selected, be aware that the stamp will engrave on the opposite side of the
page. As an example, position the stamp in the upper right hand corner of the page
and place a full sheet of rubber in the upper left side of the engraving area inside the
laser system. We recommend installing the High Resolution lens for engraving rubber
stamps. Focus on the material using the correct focusing tool and go to the ULS Printer
Driver to set the power settings. There are some sample settings in section 4.7 of this
manual for rubber stamps. They might have to be adjusted for different types of rubber
and thicknesses. When selecting “RUBBER STAMP” in the driver, notice that the
“INVERT FILL” switch automatically becomes selected. Deselect the “INVERT FILL”
option because it will not be used in this example. The following diagram shows an
example of setting up the graphics software’s page layout and positioning the rubber
engraving material inside the laser system respectively:
60