Universal Laser Systems ULS-25PS, Руководство по эксплуатации

Страница: 56 / 100

3. Next, connect the Rotary Fixture control cable to the receptacle on the laser
engraving system. If necessary, refer to the diagram at the beginning of this
chapter for the receptacle’s location.
4. Before loading the glass into the fixture, measure the diameter of the glass in the
area where the engraving is to be located by using a caliper or similar measuring
device. Remember this number or write it down.
5. Place the open end of the glass on the right side of the Rotary Fixture. Lift the lever
on the adjustable end of the fixture and slide it up against the other end of the glass
so the glass rests firmly against the padded foam disk. Do not to apply too much
pressure, especially with glass. Lower the lever on the adjustable end of the fixture
to secure it in place.
6. Turn on the laser system and wait for it to home. Press one of the directional arrow
keys on the Motion Control panel and notice that the motion system will align to the
centerline of the Rotary Fixture automatically. Now focus on the glass by using the
focus tool and adjusting the table up or down. If the glass slopes too much in the
engraving area, the Rotary Fixture can be tilted upwards to make the surface of the
glass parallel with the motion system. To do this, lift up the left end of the fixture
and place some sort of spacer underneath the fixture to prop it up. Be careful not to
raise the Rotary Fixture too high, otherwise it might interfere with the motion
system. Press the “PAUSE”
key to move the arm out of the way.
Focusing Hint: To focus without using the focus tool, turn the Z-Axis homing feature
ON. Then add 5.5 inches to 1/2 the diameter of the object. Now take the result and
enter it into the “OBJECT HEIGHT” adjustment in the Control Panel of the laser system.
Operation of the Rotary Fixture in the Landscape mode
56