Universal Laser Systems ULS-25PS, Руководство по эксплуатации

Страница: 49 / 100

PAUSE AND RESUME
The “PAUSE” button can be pressed while the system is cutting or engraving a job to
pause all operations. When paused, the motion system arm will move to its home
position in the upper right corner. When ready to resume operation, press the
“RESUME” key and the system will begin cutting or engraving again where it left off.
The “READY” indicator light will blink when the system is paused.
NEXT JOB
Pressing the “NEXT
JOB” button brings up the next job in the system buffer and makes
it the current job. Pressing the “START JOB” button starts cutting or engraving of the
job. Pressing the “NEXT JOB” button while the system is cutting or engraving a job has
no effect.
The Laser Controls
The Laser ON/OFF switch allows the laser’s power to be turned on and
off manually for emergencies. The red “LASER” indicator light will
illuminate when power is being supplied to the laser. The indicator
light is also tied in with the safety interlock system, so the light will go
on and off as the doors to the system are opened and closed.
The green “READY” indicator light serves two purposes. It will illuminate to indicate
when a job is completed and the system is ready to begin a new job, and if the
“PAUSE” key is pressed, it will blink to indicate that the system is paused. When the
laser is first powered on, the green light will blink until a job is run for the first time.
The yellow “BEAM”
indicator light will illuminate when the laser is being pulsed. This
provides a visual cue that the laser is firing. This indicator light actually signals that the
laser control board is signaling the laser to fire, so the light will continue to blink even if
the power to the laser is turned off.
49