Universal Laser Systems ULS-25PS, Руководство по эксплуатации

Страница: 87 / 100

5.2 System Cleaning
1.
Turn off and unplug the laser system.
2.
Open the Top Door and the Front Door. Thoroughly remove all loose dirt and
debris from inside the machine with a vacuum cleaner.
3.
Clean the Engraving Table surface with either soap solution, alcohol, or acetone,
and paper towels.
NEVER pour or spray any solution directly into the laser
system. Always dampen your paper towel or cloth outside of the machine with the
cleaning solution and then wipe down the parts you are cleaning with the
dampened cloth.
4.
Remove the Cover Plate, located on the right side of the laser system below the
Engraving Table Adjustment Knob, by removing the two Thumbscrews and lifting
the Cover Plate straight up and out. This will allow access to the Y-axis Motion
System Rail on the right side.
5.
Clean all of the rails of the Motion System by using either the cotton swabs or
paper towels, and alcohol or soap solution. Pay close attention to the bearing
tracks that the bearings roll in since any debris left to build up in these bearing
tracks will cause the bearings to wear and the engraving quality to become rough.
6.
After the rails and tracks are cleaned, use a clean swab or paper towel, and
alcohol to clean all of the bearings by holding the swab against each bearing and
moving the motion system by hand to roll the bearings against the swab. There
are seven bearings in the system, three(3) on the Focus Carriage, two(2) on the
left side of the X-axis Arm, and two(2) on the right side of the X-axis Arm.
7.
Clean the Top Window with a cotton cloth and the soap solution. The Top Window
is made out of acrylic.
DO NOT use paper towels because they will scratch the
acrylic. Also, DO NOT use window cleaner, alcohol, or acetone as these
chemicals will crack the acrylic. Only use cleaners designed for acrylic.
8.
Check the Intake Air Filter on the inside of the Front Door jamb of the laser system.
To remove it, reach in with your fingers and gently pull it out. If it is dirty, clean it
by submerging it in a mild soap and water solution, rinsing it clean and wringing it
dry. If the Intake Filter is allowed to become too dirty it can restrict air flow making
the exhaust less effective.
5.3 Optics Cleaning (as necessary)
A visual inspection of the #2 and #3 Mirrors, Beam Window, and Focus Lens should
be performed at least once a day.
DO NOT clean an optic that is visually clean.
Excessive cleaning can damage the optics. The #2 and #3 Mirrors and the Focus Lens
will need to be removed to clean them, the Beam Window does not.
87