Universal Laser Systems ULS-25PS, Руководство по эксплуатации

Страница: 53 / 100

The final choice on this menu system is “SET ROTARY AXIS”. The Rotary Fixture Axis
is a setting that is pre-set at the factory. The laser system will sense when the Rotary
Fixture is plugged in and will position the X-Axis arm directly over the centerline of
rotation automatically when it begins to engrave. This setting can be altered if you
position the Rotary Fixture in a location
OTHER than the pre-drilled screw holes on the
engraving table.
To change this setting, turn the laser system OFF, place the Rotary fixture on the
engraving table in the desired position, and
DO NOT plug the Rotary Fixture into the
electrical socket. Now turn the laser system ON and with the motion system arrow
buttons, position the X-Axis arm’s focal lens carriage directly over the Rotary Fixture’s
centerline of rotation as the following diagram demonstrates:
The left and right position (X-position) of the focus carriage is irrelevant in this setting.
It’s position is determined by where the graphic is placed in the graphics program,
therefore, it’s position is ignored by the laser system and cannot be set in this
procedure. Now, select the “YES SAVE Y AXIS” choice. If you change your mind and
do not wish to alter the “ROTARY AXIS” position, select “CANCEL” instead and the
original settings will be restored.
NOTE: To save this setting in the laser systems memory configuration, “RETAIN
SETTINGS” must be performed. This procedure is defined later in this section. If you
do not “RETAIN SETTINGS”, all changes that you made, even after selecting “YES
SAVE Y AXIS”, will be lost and the previous settings will remain. To restore the Rotary
Fixture back into it’s original factory condition, locate the Rotary Fixture in it’s normal
position and repeat this entire procedure.
53