Ulvac VD151, Инструкция по эксплуатации

Страница: 26 / 68

YK08-0028-DI-002-08
8
3. Mounting
WARNING
You are requested to install and operate the product in compliance with
the laws and regulations relating to the safety, e.g. Fire Defense Law,
Electric wiring regulation and so on in the country and region you use
the product. Consequently you shall be requested to attend general
safety lectures officially effective in the area, such as electrical safety,
Cargo handling safety and so on. Note that any person not attended
such lectures shall be restricted from handling the product. Operators
shall need to attend such kind of training and have special knowledge,
skill and title regarding the electricity, machinery, cargo, vacuum and
so on.
Be sure to clear any energy sources, e.g. electricity, coolant and so on
of the product before installing or removing the product.
3.1 Installation
Install the machine horizontal to a place where there are less dust and humidity. Make a layout
taking into consideration of works such as setting, removal, check, cleaning and so on.
As for the environmental condition, please refer to “0.5.3 Ambient Condition for Storage, Install
and Operation”
CAUTION
Operating the pump on laying it down or putting it reverse would give
damage to the pump. Ensure to install the pump horizontal to the
ground level as illustrated on the Fig. 2 and Fig. 3.
3.2 Lubrication
Remove the oil filling plug and fill the pump with oil until the oil level comes between the two level
lines of the oil level gauge (Refer to the “Fig. 4 Lubrication and oil level indication”).
The pump is operable if the oil level is between the two level lines of the oil level gauge during
operation.
CAUTION
1) The oil level comes down approximately 1cm when operated the
Pump.
Do not start the pump with the minimum level oil.
2) Do not operate the pump without adding pump oil. If it is operated in
an oil-less condition, the pump will be damaged.