Ulvac VD151, Инструкция по эксплуатации

Страница: 42 / 68

YK08-0028-DI-002-08
24
WARNING
It is better to use the ULVOIL R-42 having less viscosity that enables
you to start rotating the Pump around 4°C.
You should, however, replace it with the ULVOIL R-72 if the
temperature gets 10°C or more. Be cautious as using the ULVOIL
R-42 in warm season would cause such troubles as sealing error, oil
leak or more serious trouble, due to its lower viscosity.
ULVOIL R-42 is unfitted for high load operation. When performing
the high load operation, use ULVOIL R-72, and either warm the pump
oil or perform the pump jog at several times, and the start up it.
4.6 Oil mist trap (Optional)
The oil mist trap can be mounted to trap the oil mist discharged from the pump.
The TMX-1 model is for the VD151/VD201. The trap with adapter can be set on the pump instead
of the original exhaust pipe at the outlet.
1) At the outlet of the pump, remove the original exhaust pipe.
2) You assemble the adapter and TMX-1 to establish the pump.
3) Between the adapter and TMX-1, put the O-ring(G85).
Four small screws and washers fix adapter and TMX-1.
* When the adapter is attached to the TMX-1, please remove the baffle inside the trap.
4) Between the pump and adapter, put the O-ring(G30). Please set up the exhaust vent.
For more information, please see the instructions OIL MIST TRAPS.
IMPORTANT
Provide the time to return oil from TMX-1. When using VD151/VD201
at 10,000Pa or more,, arrange so that the oil returns from TMX-1 to
the pump making the not exhausted time (5 minutes) once every 30
minutes.
Upon continuing the continuous exhaust at high pressure, the oil
blocks the filter, and the pressure on the exhaust side becomes
high, and the oil blows out from the exhaust port, and also the
pressure may go bad due to the oil shortage in the pump.