Replacing/Installing a Module
Chapter 7: Maintenance
Page 7-8
VersaMux-4000 Operation & Installation Guide
Part No. 24001157
Revision C
2.
Slide the module into the chassis until the connector is seated
securely as shown in
.
Figure 7-4
Seating the Module in the Chassis
3.
Hand-tighten the captive thumbscrews located at the top corners of
the module as shown in
. This completes the installation
procedure. If you were performing a hot-swap be sure to disable the
Hot-Swap
parameter as described in
.
NOTE:
Do not tighten the thumbscrews with a screwdriver. This may stress the screw and
damage it.
Figure 7-5
Hand-Tightening the Captive Thumbscrews
RCV
EXT CLK
FIBER / CU
FRX
CRX
FTX
CTX
FIBER / CU
CRX
FTX
CTX
FIBER / CU
FRX
CRX
FTX
CTX
EXT CLK
FIBER
FRX
CRX
FIBER / CU
CRX
FTX
CTX
FIBER / CU
FRX
CRX
FTX
CTX