
-3- SCREEN PP45
28/29
2.2 TOTAL STOP SAFETY
The machine will stop immediately after one of the following errors occur:
Emergency stop.
Any of the emergency push button is pressed.
Security error.
One of the contacts of the security micros is open (emergency button
or guard micro).
Cutting cover open.
The cutting cover is not detected in its position.
Inverter error.
The inverter has an error. If you have the frontal panel (programming
panel), look for the error in the inverter’s manual.
Error in the motors.
Protection of any of the motors has been activated. Check that all
circuit breakers (QM) in the electrical cabinet are in STOP position. Push ON button
once the corresponding circuit breaker is in the original position, if it has a serial
connection with the protections of all the other motors.
Temperature excess.
The temperature of one of the heating plates is too high. Check
which one is the overheated one, looking the temperature of each one.
Water pressure error:
This error appears when switching on the machine there is no
water entering or enough water pressure.
Vacuum pump starter error.
This error will show up, when there is a fault in the
vacuum pump starter (only if the start up of the vacuum is made by a starter).
Film advance error.
You will get this message if after some time the film advancement
has not been completed. If the film does not go forward, this may mean that the film
is blocked. If advancement is too long, reset the counter with the “RESET” key in
the latter, if the machine has pulses counter reset option.
Anticipated sealing mould rise alarm.
Sealing die is detected in the upper position
before the film finishes the advance. Anticipated advance parameters need to be
changed.
Anticipated forming mould rise alarm.
Forming dies is detected in the upper position
before the film finishes the advance. Anticipated advance parameters need to be
changed.
Sealing die not up.
The sealing die is not detected in the upper position.
Sealing die not down.
The sealing die is not detected in the bottom position.
Forming die not up.
The forming die is not detected in the upper position.
Forming die not down.
The forming die is not detected in the bottom position.
Lower cut 1, don't lift up.
Transversal cutting 1 not detected in the upper position.
Lower cutting 1, not down.
Transversal cutting 1 not detected in the bottom position.
Error sealing plate down.
The sealing plate is not correctly placed, so it is not in the
upper position.
Содержание TFS100
