Ulma TFS100, Руководство пользователя, Страница: 32 / 85

-2- USE INSTRUCTIONS TFS 100
16/38
4.3 OPERATION
The control system of TFS offers a range of devices so that handling the
functions of its machines turns out to be an easy task for operators. These devices are:
•
Touch screen.
•
Start button.
•
Stop button.
•
Emergency stop button (emergency).
•
Main switch.
The touch screen is a device that helps the machine operator by indicating
him/her, in case there is an interruption, what caused the machine to stop. It also
permits handling the working mode of the machine (vacuum connection, gas, cross-
cutting, encoder, photocell, change of time, change of temperature...).
There are two cycle buttons located in the control board.
The water outlet button evacuates water from the cooling circuit and is used
when changing or loosening moulds.
The main switch is only used to start and stop the machine in normal conditions.
To start the machine, we turn on the main switch. If the coil films are already
inserted and the stop is deactivated, we can start working. In order to do so, you must
press the start button and some machine devices will start working (air circuit, water
and heaters).
When everything is ready (temperatures reached and rolls on standby) you
must press the start button again to start the auto working mode. The machine
indicated you can start the auto working mode with a blinking light on the right upper
corner of the screen. If the light does not blink and you press the start button, you will
get a message on the screen indicating the reason why you cannot start the auto
working mode.
Together with this manual, you will find enclosed a working instructions sheet
where you can find the adequate temperature and position of the elements that form
the control panel in order to correctly process the plastic film.
For the machine to stop the cycles, you must press the stop button.