UI SP-556 series, Руководство по эксплуатации

Страница: 20 / 52

- 17 -
（０２）
（０３）
（０４）
（０５）
（０６）
〔Ratio measurement〕
absolute ratio measurement ・・Ｂ／Ａ×１００
error ratio measurement ・・・・（Ｂ－Ａ）／Ａ×１００
difference measurement ・・・・Ａ－Ｂ
density・・・・・・・・・・・・・Ｂ／（Ａ＋Ｂ）×１００
sum measurement ・・・・・・・Ａ＋Ｂ
（０７）
〔differential rate measurement〕
There is a signal of two kinds of number of revolutions of A and B,
The 2 signals are input, and the following calculation is considered to be it.
Furthermore, analog output and the preset output are possible for indication
value data.
１）Calculation type
①A and B turn in the same direction：（Ａ－B）／Ｒ
〔Terminal stand 2-3 is a state of OFF〕
②A and B turn to the opposite direction：（Ａ＋Ｂ）／Ｒ
〔Terminal stand 2-3 is a state of ON〕
２）Setting method
①Set scaling of A input and B input ：（Mode No.１－4）
②Deceleration ratio (R) setting：（Mode No.５）
③Sampling time：（Mode No.６）
④Setting of the preset output（Std.）：（Mode No.８，９）
（Option）：（Mode No.Ａ，ｂ）
⑤Setting of the analog output.
（Option）：（Mode No.Ｃ，ｄ）
⑥Setting of the reverse-rotation input ：（Mode No.７）
３）Operation explanation
①A input lamp lights up when I push during a measurement,
and number of revolutions of the A input is displayed.
B input lamp lights it up when I push once again and
displays number of revolutions of the B input.
A input lamp and B input lamp turn off the light when I push
once again, and differential rate is displayed.
②Reverse-rotation input is shown terminal stand 2-3 when
short-circuit.
When, in this state, I operate the above
“
①
”
, Number of
revolutions and differential rate of each input are displayed.
Perform the A input with open collector signal or no voltage point
of contact signal
ENT
ENT
ENT
HD
Indicat e
Out put
1 2
A B
Mode 3 4
ENT
RST