uher sg 561 royal, Руководство по эксплуатации

Страница: 27 / 74

3. Use a coin to turn the voltage selector (B) to the appropriate op-
erating voltage position. The voltage selected will appear in
the recess (C), whereupon the power may be plugged into a
mains power outlet.
To adjust 50 Hz to 60 Hz Operation, a 60 Hz motor pulley (UHER
Order No. 011050) and a 60 Hz motor condenser (UHER Order
No. be installed by an experienced technician.
Attaching the Handle (Figs. 1 and 3)
Screws (E) hold the carrying handle (D) in in the threadings (F)
provided in the housing. For upright Operation of the unit, swing
the carrying handle toward the of the unit; the handle will be auto-
matically stopped on jumping into groove (G). The screws (E) should
then be turned are tight. To adjust the handle for
transportation, first loosen the screws (E). Pressing the button (G) next
to the right rubber will release it, and the handle may then
be swung up into carrying position.
Attaching and Removing the Transparent Dust Cover
The transparent cover has a locking button on each side and two hinge
plates at the rear. When placing the on the unit, the hinge plates
oooooooooooooooo
0
oooooooooooooooo
oooooooooooooo
must catch in the hinge slot in the machine, then the lid may be
down until it catches.
To open the lid, press the two locking buttons. The lid may then be
swung up (or It may be lifted off after even slightest
opening. To protect the machine from dust, the lid should be placed
on the unit after switching it off.
Loading the Tape
Before placing the spools on the spindles, pull up the two 3-pronged
pins on the spindles and turn them so that the prongs of the stationary
and movable are aligned. See position "A" in Fig. 4. Place the
on the supply spindle and an empty on the take-up
spindle (right). Then turn the pins to the right or to the left until they
fall in and catch. See position "B" in Fig. 4. The spools will then be
secured and cannot fall off. Next, run a tape lead - - from
the left spool around the left tape tension sensor, into the threading
slot and, making one or two rotations by hand, wind the beginning of
the tape lead onto the right spool. When loading the tape, the Tape
Transport Switch @ must always be in STOP position.
N)
B
Fig. 3
Fig. 4
the end-of-tape switch is activated just after the Start of
tape because the switching on the tape is still in
the tape threading tape run may be started by turning the Tape
Transport Switch ® beyond the START position. On releasing the
switch, it will automatically return to the START position, and tape
transport will begin.
25