uher sg 561 royal, Руководство по эксплуатации

Страница: 26 / 74

Setting Up the SG 561 ROYAL
1.1 Air Circulation
In setting the SG 561 care be taken that all ventilating
of the unit's are free and open to permit air circula-
tion needed for proper heat When bullding the unit into
a cabinet or set of wall shelves, be certain to allow for sufficient air supply.
1.2 Operating Position
The SG 561 be operated in either or horizontal position.
Two holes (A) are provided on the bottom side (or rear) of the unit's
housing for hanging the unit on wall (see Fig. 1).
Extension of Connecting Leads
When matching extension (see at end of Oper-
ating Instructions) are not used, connecting leads should be extended
by an service
Fig. 1
24
A.C. Mains Connection, Operating Voltage and Mains Fuse
(Figs. 1 and 2)
The power is located in the recess (B) in the (or rear)
of the unit's housing. To open the compartment lid, push the self-catching
key (C) of the lock in the direction indicated by the arrow and the
lid up or out.
Before plugging the lead into a mains power outlet - especially when
outside of Germany - ascertain the voltage of the power supply. The
SG 561 has been factory-set to an operating voltage of 220 V A.C. 50 Hz,
but it may be adjusted to operate on V, 130 V, 150 V, 240 V or
250 V.
To adjust the voltage, proceed follows (see Fig. 2):
1. certain that the machine is disconnected the mains
power supply. Using a coin, then unscrew the fuse holder (A)
the voltage selector (B) is located in the power compart-
ment.
2. For Operation on voltages from 220 V to 250 V, insert an 0.6 A
fuse; for voltages from V to V use a 1.2 A fuse. Then screw
the fuse holder back in.
A B C
110-150 V 1,2 AI
= 0,6 At
Fig. 2