PAGE 3 OF 19
0923 IH-3532
INSTRUCTIONS CONTINUED
6.
Clinch Adjustment
– Turn special nut clockwise to
tighten clinch and counterclockwise to loosen clinch.
Use a tool to fit 1/8" (3 mm) hole. (See Figure 5)
NOTE: Remove adjusting tool after adjustment.
7.
Depth Adjustment
– Loosen front screw and adjust
to desired length. When the top edge of adjustment
plate is at highest setting (#4), the clinchers are at
their shallowest penetration. If set at lowest setting
(#1), the clinchers are at their deepest penetration.
(See Figure 6)
NOTE: Tighten screw after adjusting stapler.
OPERATION
TRIGGER-OPERATED STAPLER
a. With finger off the trigger, hold the stapler with a
firm grip on the handle.
b. Place the nose of the stapler against the work.
c. Pull the trigger to drive.
WARNING! This is a full-cycle stapler. The stapler
will cycle each time the trigger is pulled!
Clinchers will discharge and retract.
Stapling
– Grasp handle with one hand. Position on
box in line with the desired staple location. There is
a small projection on either side of the frame as an
aid in locating the position of the staple. Press trigger.
Strongest closure requires end staples close to end
of box. Check packaging requirements. Test staple
clinching in a sample of the board being used. Adjust
clinch for depth of penetration and tightness.
(See Figure 7)
STOP: Always disconnect air supply:
• Before making adjustments;
• When servicing the stapler;
• When clearing a jam;
• When stapler is not in use;
• When moving to a different work area, as
accidental actuation may occur, possibly
causing injury.
Adjustment
Plate
Front
Screw
NO. 1
NO. 4
NO. 2 & 3
Special
Nut
Tight
Medium
Loose
Clinch
Tight
Loose
Figure 5
Figure 6
Figure 7
