PAGE 2 OF 19
0923 IH-3532
• The connector on the stapler must not hold
pressure when air supply is disconnected. If a
wrong fitting is used, the stapler can remain
charged with air after disconnecting and thus will
be able to drive a fastener even after the air line is
disconnected, possibly causing injury.
• Do not pull trigger or depress contact arm while
connected to the air supply as the stapler may
cycle, possibly causing injury.
STOP: Always disconnect air supply:
• Before making adjustments;
• When servicing the stapler;
• When clearing a jam;
• When stapler is not in use;
• When moving to a different work area, as
accidental actuation may occur, possibly
causing injury.
SAFETY CONTINUED
LOADING THE MAGAZINE
1. Disconnect from air supply.
WARNING! When loading stapler, never place
a hand or any part of the body in fastener
discharge area of the stapler. Never point
stapler at anyone. Do not pull the trigger or
depress the trip as accidental actuation may
occur, possibly causing injury.
2. Pull back the pusher until it is tucked under the rear
of the magazine in position 1. (See Figure 1)
3.
Check staple leg length
– Adjustment is provided in
the H-3532/H-3534 for different staple leg lengths.
a. To adjust machine for leg length, loosen set
screw and turn pivot pin 180º with a screwdriver
to the desired adjustment as noted. Tighten set
screw. (See Figure 2)
b. To change shallow clinchers (see parts chart for
part numbers) remove screws and front bracket
to provide access to clinchers. Change one at
a time to prevent reversing part. Also part #45
will need to be changed to specified spacer in
the table. (See Figure 3)
4. Load the staple stick from the rear of the tool.
5. Slide the pusher from position 1 to the rear of the
staple stick. (See Figure 4)
INSTRUCTIONS
Figure 1
Position 1
Figure 2
Screwdriver
Pivot Pin
Front Bracket
Set
Screw
Figure 3
Figure 4
