Troubleshooting and Maintenance
66
Document Number 206465-0001
User Guide
Note:
Make sure the tip remains all the way up against the heater
block as you tighten the screws.
Figure 56: Tighten heater block clamp screws.
8.
Repeat steps 3 through 8 for the other tip if necessary.
9.
Replace head cover and close the printer door.
10. The printer will display
Tip Maintenance - Tips Replaced?
- press
Yes
to begin material load.
A. The printer will display
Load Model - Replace Both Carriers
(flashing).
•
If you want to replace a material carrier, do so now.
•
If you do NOT want to change a material carrier, you must unlatch and latch the carriers to continue
(Push the carrier forward to unlatch, then push it forward again to latch). Because the material
‘unloaded’ during the tip replacement, the printer is in the material replacement mode. You must
unlatch and then latch the carriers to continue. If there is a delay in the unlatch/latch process, the
printer will display
Both Carriers Not Replaced Or Invalid
. Select Retry, then unlatch and latch the
carriers.
B. The printer will now begin to load material.
C. After material loading is complete the printer will display
Tip Calibration - Install Modeling Base
And Build Calibration Part
.
Note:
Make sure a NEW modeling base is installed before starting
calibration. Calibration results will be incorrect if a NEW
modeling base is not used.
Tighten screws
Tighten screws
