Setup
24
Document Number 206465-0001
User Guide
Setting the static network address:
1. Obtain your static network address from your Network Administrator.
2.
From
Idle
(or
Ready to Build
), press
Maintenance
on the display panel. The display will show
Main-
tenance
and the software version.
3.
Press
System
.
4.
Press
Set Network
. The top window displays:
Network Admin - Static IP Address
;
UDN
.
5.
Press
Static IP
to display current settings. For example:
IP Address:
192.000.000.001
NM Address: 255.255.000.000
GW Address: 198.000.000.001
Note:
These values are the factory defaults and MUST be changed
for your network. If these values are not changed the printer
will continue to restart itself until they are changed.
6.
Look for the cursor beneath the first digit of the IP Address. The cursor does not blink. To update the
IP
address:
Press
Increment
to increase the value one digit at a time.
Press
Next Digit
to move the cursor one place to the right.
Press
Last Digit
to move the cursor one place to the left.
7.
Use the three functions listed above to set your IP address.
8.
After setting the final digit of the Internet Protocol (IP) address, move the cursor one more place to the
right. The cursor moves to the Netmask (NM) address. Follow the same steps for setting the NM and
Gateway (GW) addresses.
9.
When you have finished setting the addresses, from the display panel press
Done
. The display will
show:
Change IP, Netmask and Gateway?
10. Press
Yes
. The panel then displays
Resetting Network
and after a moment returns to
Idle
or starts
warming up.
11. From your PC, start the CatalystEX application.
A. From the General Tab, click the
Manage 3D Printers
button.
B. Click the
Add from Network
button in the lower right corner of the pop-up window.
C. A new pop-up window,
Add 3D Printer
, should list your printer in the main window (identified by its
UDN). Click on the printer in this window and enter a name and location in the lower portion of the
pop-up window.
D. Click
Add Printer
and you are ready to go. Close the 3D Printer pop-up window.
