TYM T233 HST, Руководство по обслуживанию

Страница: 212 / 232

Problems Causes Countermeasures
Individual
turn signal
light does not
illuminate Burnt out bulb Check and renew
Corroded or loose bulb contacts Inspect,clean,and renew
Poor ground connection or damage
wiring Inspect,clean,and tighten connections or
renew wiring
Turn signal
pilot light is
inoperative Faulty bulb Check and renew
Defective flasher unit Check and renew
Faulty wiring or connections Inspect,clean,and tighten connections or
renew wiring
Stop lights
does not
illuminate Inoperative stop light switch Check and renew
See “Individual lights do not
illuminate” See “Individual lights do not illuminate
Inoperative
work light Work light switch is not turned on Ensure work light illuminates
See “Individual lights do not
illuminate See “Individual lights do not illuminate
Problems Causes Countermeasures
2. INSTRUMENTATION
10-16
Inoperative or
erratic meters Loose or broken wiring Inspect Circuit, tighten connections or renew
wiring
Defective meters Inspect and renew
Defective sensors Check and renew
Defective Voltage regulator Check and renew voltage regulator (Alternator)
Monitor light
does not
illuminate Loose or broken wiring Inspect circuit,tighten connections or renew
wiring
Faulty main switch Check and renew
Burnt out bulb Check and renew
Burnt out fuse Check and renew
Defective switch Check and renew
Loose or broken wiring Check and renew
PTO does not
operate Burnt out fuse Inspect and renew.Check circuit
Loose or broken wires or
connections Inspect circuit,tighten connections,or renew
wiring
Defective PTO switch Check and renew
Defective PTO solenoid Check and renew