FIG. 16
Next, locate the
Guide Rod Retainer Housing (#25)
and, usin
a rubber mallet, insert two Plastic Insert Caps 1 X 2 ( #37) into the tube
ends, as shown in caption above.
Maneuver each of the
Guide Rod
(#21)
into the holes located on the bottom side of the
Guide Ro
Retainer Housing (#25)
.
FIG. 18
The two
Pivot Axles 1 X 8 1/8 (#39)
have been pre
assembled to the
Press Bar Selector Housing (#2)
.
Use the supplied
Hex Key 3/16" (#79) to loosen the Set Screws 3.8-16 X 1/2 (#43) that hol
the
Pivot Axles 1 X 8 1/8 (#39)
into place. Next, attach the
Press Ba
Selector Housing (#2)
to the
Top Pulley Housing (#5)
and, using a rub
ber mallet, insert the
Pivot Axles 1 X 8 1/8 (#39)
through the holes in th
Press Bar Selector Housing (#2)
and through the receptacle of the
To
Pulley Housing (#5)
until it is flush with both sides.
Note
: It is recommended to grease the
Pivot Axle 1 X 8 1/8 (#39
with multi-purpose grease prior to assembling. Also, the four Plas
tic Insert Caps 2" Sq. (#66) located in the tube-ends of the
Pres
Bar Selector Housing (#17)
have been pre-assembled by the fac
tory.
IG. 15
Next, locate the
Selector Pin w/Coil (#24)
and attach it to the
op Plate Selector Bar (#22)
as shown above.
IG. 17
Mount the
Guide Rod Retainer Housing (#25)
along with the
wo captive
Guide Rods (#21)
to the side of the
Top Pulley Housing (#5)
nd secure them into place using one
Support Plate 1/4 X 2 X 5 (#71)
,
wo Hex Head Cap Screws 3/8-16 X 3 1/4 (#49), four Flat Washers SAE
/8 (#45) and two Nylon Insert Lock Nuts 3/8-16 (#51).
Fully Fasten
: Proceed to align and fully fasten this hardware
assembly and all the previous assemblies that were left loosely
fastened. (Assemblies described in
Fig.6, Fig.7, Fig.8, Fig. 10
and
Fig.11
).
CFM-500 Compact Frontal Machine
6
Owner’s Manual: Assembly Instructions
LLY FASTEN
