IG. 39
Next, install a Nylon Pulley 4 1/2 Rd. (#26-Labeled I) into the
ulley bracket located on the
Leg Extension Arm (#20)
and secure it into
lace using one Hex Head Cap Screw 3/8-16 X 1 3/4 (#50), two Flat
Washers SAE (#45) and one Nylon Insert Jam Lock Nut 3/8-16 (#48).
Next, route the
Leg Extension Cable (#12)
under the Nylon Pulley 4 1/2
Rd. (#26-Labeled I), then secure it into place using one Hex Head Cap
crew 1/4-20 X 1 1/2 (#63) and one Nylon Insert Lock Nut 1/4-20 (#64).
Note:
Refer to
Fig. C
on page 16 for further illustration of this
assembly.
FIG. 40
Next, route the
Leg Extension Cable (#12)
through the
Fron
Upright (#4)
, then under the Nylon Pulley 4 1/2 Rd. (#26-Labeled J
Secure the Nylon Pulley 4 1/2 Rd. (#26-Labeled J) into place using one
Hex Head Cap Screw 3/8-16 X 1 3/4 (#50), two Flat Washers SAE 3/8
(#45) and one Nylon Insert Jam Lock Nut 3/8-16 (#48).
IG. 41
Lift the end of the
Leg Extension Cable (#12)
and route it
hrough the
Adjustable Double Pulley Bracket (#40)
and over the Nylon
Pulley 4 1/2 Rd. (#26-Labeled K), as shown above.
FIG. 42
Connect the looped end of the
Leg Extension Cable (#12)
t
the pulley bracket located on the
Base Frame (#3)
, as shown above
Secure this assembly using one Hex Head Cap Screw 3/8-16 X 1 3/4
(#50), two Flat Washers SAE 3/8 (#45), two Nylon Spacers 3/8 X 3/
(#35) and one Nylon Insert Jam Lock Nut 3/8-16 (#48).
Note:
Refer to
Fig. D
on page 16 for further illustration of thi
assembly.
CFM-500 Compact Frontal Machine
12
Owner’s Manual: Assembly Instructions
