29
C
H
:
0
0
H
P
L
S
:
E
N
A
N
O
_
P
6
O
R
G
.
S
T
A
R
T
:
C
C
W
M
(
C
C
W
)
O
F
F
S
E
T
.
P
U
L
S
E
:
9
9
9
9
9
M
E
M
.
P
O
S
:
N
O
_
H
O
M
E
.
P
O
S
5-6 Page6 Home position setting
1.
: SETUP channel selection
Same as Page 1.
2.
: Home position switch setting: ENA/DIS default: ENA
Set the enable or disable of the home position switch.
ENA:
It detects the home position signal
DIS:
It does not detect the home position signal
.
3.
:
Home position switch contact setting
: N.O/N.C default :N.O
Set the contact logic of the home position switch.
The right "_" will change to "□" when home position switch is active.
N.O:
Select when using the home position switch normally open (A contact).
N.C:
Select when using the home position switch normally close (B contact).
4.
: Selection of running direction for detect the origin point: CW/CCW default:CW
In carrying out the home position detection in automatic, it is the direction you want
to move to the first by pressing the START button.
CW:
Set to CW the origin detection start direction
CCW:
Set to CCW the origin detection start direction
5.
:
Origin detection direction
: CW/CCW
When it is stopped by detecting the origin, direction heading for the origin will be
recorded
.
You cannot change this value.
6.
:
Origin detection offset pulse
: Setting range: 1 ~ 9999 initial value: 100
In carrying out the re-detection of the origin, set the range to be detected at a reduced
speed at the origin around the position.
7.
: Home position of origin point:
Setting range: -2,147,483,647 ~ +2,147,483,647
Initial value: NO_HOME.POS
When origin point had been set, this position data is displayed.
When origin point hadn't been set, display is "NO H.P.".
In the case of undetected origin, the origin that was last set will be set by the "CHG"
button. When the origin has been set, you can change the origin position by entering
a value in the numeric keypad. In addition, it is possible to cancel to the state of
origin undetected in the "CHG" button at this time.
1
2
3
4
5
6
7
